Setting Up A Docucolor 4 Lp/Cp Print Queue For Bindery - Xerox DocuColor 4 Administrator's Manual

4.3 Configuring a NetWare server for printing
To activate the bindery context:
4
4.3.4

Setting up a DocuColor 4 LP/CP print queue for bindery

For NetWare 3.x and for 4.x in emulation, the NetWare print server and print
queue for DocuColor 4 LP/CP are created and configured from NetWare Print
Console (PCONSOLE), a NetWare utility that is stored in NetWare's PUB-
LIC directory.
As with NDS, first you create several NetWare entities on a Novell server,
then you select them in Network Setup on the DocuColor 4 LP/CP control
panel.
To set up a NetWare bindery print server for printing to the
DocuColor 4 LP/CP:
82
If you cannot reboot the NetWare server at this point, type the set
command manually at the server's colon prompt.
Use the same command as you entered in the autoexec.ncf file (in step 6
of the previous procedure).
If you can reboot the NetWare server, the set command is loaded
automatically.
You are ready to set up the DocuColor 4 LP/CP print server and print
queue. See the next section for details.
Log in to the NetWare server as the Supervisor.
At the NetWare MS-DOS prompt, type pconsole.
If you are using NetWare 4.x in bindery mode, Print Console
(PCONSOLE) has two modes. Press the F4 key to switch to Bindery mode.
The Available Options menu is displayed.