Token Ring Support For Docucolor 4 Lp/Cp - Xerox DocuColor 4 Administrator's Manual

4.10
Token Ring Support with DocuColor 4 LP/CP
The DocuColor 4 LP/CP supports Token Ring networks with the optional
token ring adapter card;
Token Ring PCI PCBA Part# 45000052
Token Ring supports: AppleTalk, TCP/IP, and IPX networks simultaneously.
Fiery WebTools, WebSpooler, and Web Downloader are also accessible from
the token ring environment.
Printing types supported: IPX/SPX, SMB, TCP/IP, LPR
All configurations for the above printing methods are the same as 10/100
based networks setup, only IP subnets within their respective segments will
change according to the particular LAN configurations.
Token Ring Installation
4
Be sure machine is turned off and power is unplugged! Also be sure to
properly ground yourself, as you will be working with sensitive electrostatic
equipment. Facing the front of the machine, pull off the right side panel
located near the existing Ethernet port on the rear of the machine. Insert the
Token Ring board, in the respective PCI slot. Secure the board with the two
screws provided with the card. Close the cover, and boot the system. Go
into systems setup, I/O Port Setup, and disable Ethernet, and enable Token
Ring. Ethernet must be turned off, and should not run simultaneously with
Token Ring. Configure token ring port speed, 4, 16, or auto detect. Proceed
with your local LAN configuration setup.
Section B.4 illustrates how to insert the Token Ring board into the PCI slot of
the DocuColor 4.
96
Token Ring Support with
DocuColor 4 LP/CP