How To Stop Monitoring A Route; How To Select What Parts Of A Route To Display - Furuno FMD-3200 Operator's Manual

About monitoring routes
When you choose a route for monitoring, the messages shown below appear, on
the [Select Route] dialog box or in a message window, when a route cannot be
opened for monitoring.
• "Impossible turn at waypoint XX" (XX=waypoint no.). Geometry of the route
makes it impossible for the ship to accomplish a turn. Modify the route to make
the turn possible.
• "Unchecked / Check condition differs". The route has not been checked. Check
the route, on the [Alert Parameters] page.
• "Monitored in the NAVI mode". The route is currently being monitored.
• "More than one WPT needed". The route has only one waypoint. Add more way-
points to the route.
• "Route monitoring cannot be started. Please check ship's position and condi-
tions." Click the [OK] button to close the message. Check ship's position and
conditions of the route.
If you have small-scale chart(s) on display that have the whole eastern/western (0-
180°E/0-180°W) hemisphere and a part of the other hemisphere on display, there
is a limitation to display a route. To avoid this, set chart center so that the whole
eastern/western hemisphere is not on the screen.
Six routes, one active and five plan, can be shown simultaneously in the Voyage
navigation mode.
Route monitoring is stopped and an alert appears when the GPS position, heading or
SOG/COG is lost. Restore lost data then restart route monitoring .
11.2

How to Stop Monitoring a Route

In the Voyage navigation mode, click the [Route] and [Unselect] buttons.
11.3

How to Select What Parts of a Route to Display

You can specify what parts of the monitored route to display. Click the [DISP], [SET]
and [Symbol DISP] buttons on the InstantAccess bar.
11. HOW TO MONITOR ROUTES
11-3