How To Reset Odometer And Trip Meter - Furuno FMD-3200 Operator's Manual

Check position sensors (POSN page)
Open the menu and click the [POSN] tab in the [System Sensor Settings] page or [Lo-
cal System Settings] page. The [Prim] and [Second] labels indicate the type of the po-
sition sensor. (In the figure below the [Prim] label shows GPS1). [Prim] and [Second]
indicate sensor status and priority.
Only one sensor can be primary while the others can be secondary or off position. Af-
ter a sensor is turned off, its status is changed to Secondary state. When a position
sensor state is changed to primary and another sensor was primary, the sensor for-
merly primary becomes secondary.
Select the "Primary" navigation sensor as the sensor that is considered to be most ac-
curate and reliable. Set all other navigation sensors as "Secondary".
2.11.5

How to reset odometer and trip meter

To reset the odometer and/or trip meter do as follows:
1. Open the menu and select the [Voyage] menu from the [NAVI Log] menu.
2. Click one of the following buttons as appropriate.
Reset Trip: Reset the trip distance.
Reset All: Reset both the odometer and the trip meter.
3. Click the [Close] button to finish.
2. OPERATIONAL OVERVIEW
2-27