Furuno FMD-3200 Operator's Manual page 26

1. INTRODUCTION
Stablilization
mode
LOG/GPS
selection
5. For automatic input, follow the procedure below. For manual input, go to step
6.
1) Check [Sensors].
2) Set the priority for the speed sensors in case of Local sensor. Click the triangle
on any line then select the sensor to set as the primary source of speed. All
other sensors are then set as secondary source. Only one sensor can be pri-
mary while the others can be secondary. If a speed sensor is changed from
secondary to primary state and another speed sensor was selected as prima-
ry, then that sensor previously selected to primary state is then automatically
selected to secondary state.
3) Check [LOG] or [GPS] at [Sensor Type] as appropriate.
4) Select [Bottom] or [Water] at [Stabilization Mode]. Select [Bottom] if GPS is the
source of speed data, or [Water] if a speed log is the source of speed data.
5) Go to step 7.
6. For manual input, set the stabilization mode for [Water] and check [Manual]. Enter
the speed, using the scrollwheel or software keyboard.
Note: For set and drift, see page 17-3.
7. Click the [Save] button to save settings then click the [Close] button to close the
menu.
Notes on speed input
• Be sure not to select a LOG option when a speed log is not connected. If the log
signal is not provided, the ship speed readout at the top of the screen will be blank.
In the event of a log error, enter speed manually.
• The SPD is shown as "*.* kn", the label "LOG" (in red) appears if no log signal is
present for 30 s.
• With the serial speed inputs and SOG selection, if the type of data is changed from
SOG to STW the label "LOG" (in red) appears.
• A single-axis water log cannot measure speed when the wind is coming from the
leeway direction.
1-10
Check for automatic speed input
Check for manual speed input
SPD page, system sensor
Speed
sensor
list