FUEL SYSTEM
I nstall the 0-ring on the float chamber groove.
I nstall the float chamber and tighten the screws securely .
NOTE
I nstall the fuel tube clamp.
•
VAC U U M CHAM B E R
I nstall t h e washer, jet needle, spring and needle holder t o the
vacuum piston.
Push the jet needle holder i n and turn it in
kwise .
Hold vacuum piston u p to almost full open to avoid pinching
the diaphragm with the chamber cover.
The vacuum piston with the tab of the diaphragm aligned with
the groove of the carburetor.
I nstall the chamber cover with the spring, aligning the cover
cavity with the hole i n the carburetor, and secure with at least
two screws before releasing the vacuum piston.
4- 1 2
degrees cloc
9 0
( 2 ) CAVITY
J ET NEEDLE
(1 l
HOLDER
(4) F I N G E R