HYDRA U L I C DISC BRAKE
I nstal l the snap ring using a snap ring pliers.
Install the boot .
•
CAUTION
Be certain that the snap ring is seated firmly in the groove.
TOOL:
Snap ring pliers
Install t h e brake lever a n d brake light switch.
I N STALLAT I O N
Set the master cylinder onto the handlebar with the holder
" U P" mark facing up.
Temporarily install the holder bolts. Align the slit of the master
cylinder with the punch mark on the handlebar.
Tighten the upper bolt first, then the lower bolt.
Connect the brake light switch wires to the switch terminals.
I nstall the rear view mirror.
Connect the brake hose with the oil bolt and two sealing wash
ers and tighten the oil bolt.
TORQU E : 30 N·m (3.0 kg � m. 22 ft-lb)
Fill the reservoir with DOT 4 brake fluid to the casting ledge
and bleed the brake system (page 1 4- 4) .
1 4- 1 0
079 1 4 - 323000 1
or equivalent commercially
available in U . S
A .
.
SNAP RING
( 1 )
( 2 ) BOOT
) BRAKE LEVER
/
I 1