Brake Caliper Assembly - Honda VT600C Shadow VLX Service Manual

HYDRAULIC D I S C BRAKE
A S S E M BLY
Coat new piston seals and dust seals with clean brake fluid
and install them in the caliper.
I nstall the pistons anrJ i nstall them with the open ends toward
the pads.
Instal l the pad spring on the caliper as show n .
Apply silicone grease t o t h e inside o f t h e boot, and instal l it.
I nstall the retainer spring as shown.
Apply silicone grease to the inside of the boot and install it.
I nstall the following:
- pads and pad pins to the caliper
- bracket to the caliper
I nstall the caliper assembly over the brake disc so that the disc
is positioned between the pads.
•
CAUTION
Be careful not to damage the pads.
I nstall and tighten the caliper mounting bolts .
TO R Q U E : '88,'89,'9 1 -'93: 27 N · m (2.7 Kg- m,20 ft-lb)
After'93:
Tighten the pad pins and i nstall and tighten the pad pin plugs.
Connect the brake hose to the caliper with the hose bolt and
two new sealing washers.
TORQU E: 30 N·m (3.0 kg-m, 22 ft-lb)
Bleed the air from the brake system (page 1 4-4) .
1 4 - 1 2
3 1 N · m (3. 1 Kg- m,22 ft-lb)
( 2 ) D U ST SEALS
(3) SILICONE
( 1 ) RETAINER
( 2 ) BOOT
SPR ING
(2) SILICONE