Habdlebar Grip Replacement; Handlebar Removal - Honda VT600C Shadow VLX Service Manual

HAN DLEBAR
G R I P R E PLAC E M E N T
Remove t h e right handlebar switch screws a n d disconnect the
throttle cables from the throttle pipe.
Remove the grip end cap and right handlebar grip.
Remove the grip from the throttle pipe.
Apply Honda Bond A or Honda Grip Cemment ( U . S . A . only) to
the inside surface of the throttle grip to the clean surface of
the throttle pipe. Wait 3 - 5 minutes and install the grip. Rotate
the grip for even application of the adhesive .
Connect the throttle cables to the throttle pipe and i nstall the
right handlebar switch.
I nstall the grip end cap.
Remove the grip end cap and pull the grip off of the left handle­
bar.
Apply Honda Bond A or Honda Grip Cemment ( U . S . A . only) to
inside surface of the left grip to the clean surface of the
handlebar. Wait 3 - 5 minutes and install the grip. Rotate 1:he
grip for even application of the adhesive.
NOTE
Allow the adhesive to d ry for a n hour before using . Check
•
for smooth throttle operation after the right grip is installed .
I nstall the grip end cap.
R E M O V A L
Disconnect the clutch switch wires from the switch terminals.
Remove the following:
- rear view mirror from the clutch lever holder
- clutch lever holder mounting bolts and holder
- left handlebar switch wire bands.
- left handlebar switch screws and switch
FRONT WH EEL/SUSPENSION/STEERING
(3)
ROTTLE PIPE ( 2 ) G R I P END CAP
( 1 ) C E M M ENT
( 1 ) CEMMENT
1 2-3