Left Crankcase Cover Installation - Honda VT600C Shadow VLX Service Manual

ALTERNATO R/STARTER CLUTCH
Instal l the flywheel, aligning the woodruff key on the crank­
shaft with the flywheel keyway.
Hold the flywheel with the flywheel holder, install the washer
and flywheel bolt and tighten the bolt.
TORQUE: 1 30 N·m ( 1 3 . 0 kg-m, 94 ft-lbl
TOOL:
Flywheel holder
NOTE •
The flywheel bolt has left hand threads.
Install the starter idle/reduction gear with the longer shaft .
Install the starter d rive gear with the " O UT" mark facing out
and the shorter shaft .
Install t h e dowel p i n s a n d n e w gasket .
LEFT CRAN KCASE COVER I NSTALLATION
Install the left crankcase cover a n d tighten t h e cover bolts with
the neutral and oil pressure switch wire harness clamps as
shown.
Route the alternator wire and connect the alternator 3P con­
nector.
Install the drive sprocket cover and the left side cover.
Check the oil level and add oil if necessary .
8-6
07725-0040000
Equivalent comm ercially
available i n U . S.A.