Using Usb Interface To Setup Ethernet Interface - Wasp WPL25 User Manual

WPL25/WHC25 User Manual

3.4.1 Using USB Interface to Setup Ethernet Interface

1. Connect the USB cable between the computer and the printer.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicking on the
Note: This utility works with printer firmware V6.00 and later versions.
4. The Diagnostic Utility default interface setting is USB interface. If USB interface is connected
with printer, no other settings need to be changed in the interface field.
5. Click on the "Ethernet Setup" button from "Printer Function" group in Printer Configuration tab
to setup the IP address, subnet mask and gateway for the on board Ethernet.
18
icon.