Install Microsd Memory Card - Wasp WPL25 User Manual

WPL25/WHC25 User Manual
The default IP address is obtained by DHCP. To change the setting to static IP address, click
"Static IP" radio button then enter the IP address, subnet mask and gateway. Click "Set IP" to
take effect the settings.
Users can also change the "Printer Name" by another model name in this fields then click "Set
Printer Name" to take effect this change.
Note: After clicking the "Set Printer Name" or "Set IP" button, printer will reset to take effect the
settings.
8. Click "Exit" button to exit the Ethernet interface setup and go back to Diagnostic Tool main
screen.
Factory Default button
This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and reset
the printer name.
Web Setup button
Except to use the Diagnostic Utility to setup the printer, you can also explore and configure the
printer settings and status or update the firmware with the IE or Firefox web browser. This
feature provides a user friendly setup interface and the capability to manage the printer
remotely over a network.

3.5 Install MicroSD Memory Card

1. Open the SD memory card cover.
20