Lcd Display (Wpl25) - Wasp WPL25 User Manual

WPL25/WHC25 User Manual

5.3 LCD Display (WPL25)

This section lists the LCD display messages that you may encounter when operating the printer. Also,
it provides solutions.
Head Open
No Paper
Paper Jam
Out of Mem
Take Label
Check if print density is set properly. Adjust the print density and print
Check print head test pattern if head
element is damaged.
Messages
* The printer top cover is open.
* Running out of label.
* The label is installed
incorrectly.
* Gap/black mark sensor is not
calibrated.
* Gap/black mark sensor is not
set properly.
* Make sure label size is set
properly.
* Labels may be stuck inside
the printer mechanism.
* The space of FLASH/DRAM
or MicroSD card is full.
* Peel function is enabled.
Waiting user to take label
away to print the next label.
speed.
Run printer self-test and check the
print head test pattern if there is dot
missing in the pattern.
Possible Cause
33
Recovery Procedure
* Please close the top cover.
* Supply a new label roll.
* Please refer to the steps in
user's manual to reinstall the
label roll.
* Calibrate the gap/black mark
sensor.
* Calibrate the gap/black mark
sensor.
* Set label size correctly.
* Delete unused files in the
FLASH/DRAM or MicroSD card.
* Please take the label away to
print the next label if peeler
module is installed.
* If peeler module is installed and
label is been taken away, but
the message remains. Please
check if the peeler module
connector is connected to main
board properly.
* If peeler module is not installed,
please disable the peeler
function.