Printer Function (Calibrate Sensor, Ethernet Setup, Rtc Setup; Setting Ethernet By Diagnostic Utility (Wpl25) - Wasp WPL25 User Manual

WPL25/WHC25 User Manual

3.3.2 Printer Function (Calibrate sensor, Ethernet setup, RTC setup.....)

1. Select the PC interface connected with bar code printer.
2. Click the "Function" button to setting.
3. The detail functions in the Printer Function Group are listed as below.
Note: For more information about Diagnostic Tool, please refer to the diagnostic utility quick
start guide in the CD disk \ Utilities directory.

3.4 Setting Ethernet by Diagnostic Utility (WPL25)

The Diagnostic Utility is enclosed in the CD disk \Utilities directory. Users can use Diagnostic Tool to
setup the Ethernet by USB and Ethernet interfaces. The following contents will instruct users how to
configure the Ethernet by these interfaces.
Function
Calibrate the sensor specified in the Printer
Calibrate Sensor
Setup group media sensor field
Setup the IP address, subnet mask, gateway
Ethernet Setup
for the on board Ethernet
Synchronize printer Real Time Clock with
RTC Time
PC
Print Test Page Print a test page
Reset Printer Reboot printer
Initialize the printer and restore the settings
Factory Default
to factory default.
Dump Text To activate the printer dump mode.
Ignore AUTO.BAS Ignore the downloaded AUTO.BAS program
Configuration Page Print printer configuration
17
Description