Printer Initialization - Wasp WPL25 User Manual

Hide thumbs Also See for WPL25:

Table of Contents

WPL25/WHC25 User Manual

Notes:

1. Dump mode requires 2" wide paper width.

2. Turn off / on the power to resume printer for normal printing.

3. Press FEED button to back to the previous menu.

4.3.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.

Printer initialization is activated by the following procedures.

Turn off the power switch.

Hold on the button then turn on the power switch.

4. Release the button when LED turns green after 5 amber blinks. (Any green will do during the

5 blinks).



The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5 blinks) 

red/amber (5 blinks)  solid green

Printer configuration will be restored to defaults as below after initialization.

ASCII Data

Parameter

Speed

Density

Label Width

Default setting

127 mm/sec (5 ips) (203DPI)

2" (50.8 mm)

Hex decimal data related to left

column of ASCII data

Table of Contents

Whc25