Setting Ethernet By Diagnostic Utility; Using Usb Interface To Setup Ethernet Interface - Wasp WPL304 User Manual

Hide thumbs Also See for WPL304:

Table of Contents

WPL 304 User Manual

3.6 Setting Ethernet by Diagnostic Utility

The Diagnostic Utility is enclosed in the CD disk \Utilities directory. Users can use Diagnostic

Tool to setup the Ethernet by RS-232, USB and Ethernet interfaces. The following contents

will instruct users how to configure the Ethernet by these three interfaces.

1. Connect the USB cable between the computer and the printer.

2. Turn on the printer power.

3. Start the Diagnostic Utility by double clicking on the

Note: This utility works with printer firmware V6.00 and later versions.

4. The Diagnostic Utility default interface setting is USB interface. If USB interface is

connected with printer, no other settings need to be changed in the interface field.

5. Click on the

Configuration tab to setup the IP address, subnet mask and gateway for the on

board Ethernet.

Ethernet Setup

button from

Printer Function

group in Printer

icon.

Table of Contents

Show Quick Links

Table of Contents