Maintenance Page Defination; Maintenance/Network Settings - Grandstream Networks GXV3240 Administration Manual

MAINTENANCE PAGE DEFINATION

MAINTENANCE/NETWORK SETTINGS

Address Type
DHCP Host name (Option 12)
DHCP Vendor Class ID
(Option 60)
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
PPPoE Account ID
PPPoE Password
Alternate DNS Server
Second Alternate DNS Server
Enable LLDP
Layer 3 QoS for SIP
Layer 3 QoS for Audio
Firmware Version 1.0.3.6
It is used to configure the appropriate network settings on the phone.
Users could select from "DHCP", "Static IP" or "PPPoE"(Point-to-point
Protocol over Ethernet). By default, it is set to "DHCP".
It is used to configure the name of the client in the DHCP request. It is
optional but may be required by some Internet Service Providers.
It is used to configure the vendor class ID header in the DHCP
request.
The default setting is Grandstream GXV3240.
It is used to configure the phone's static IP address if the static IP is
used.
It is used to configure the network's subnet mask if the static IP is
used.
It is used to configure the network's gateway address if the static IP is
used.
It is used to configure the primary DNS IP address if the static IP is
used.
It is used to configure the secondary DNS IP address if the static IP is
used.
It is used to configure the PPPoE account ID if the PPPoE is used.
It is used to configure the PPPoE password if the PPPoE is used.
It is used to configure the alternate DNS IP address to failover during
the default DNS server's outage.
It is used to configure the secondary alternate DNS IP address to
failover during both the default DNS server and alternate DNS
server's outage.
It is used to enable the LLDP (Link Layer Discovery Protocol) feature
on the phone system. If it is set to "Yes", the phone system will
broadcast LLDP PDU to advertise its identity and capabilities and
receive same from a physical adjacent layer 2 peer. The default
setting is "Yes".
It is used to define the Layer 3 packet's QoS parameter for SIP
messages in decimal pattern. This value is used for IP Precedence,
Diff-Serv or MPLS. The default setting is 48 which is equivalent to the
DSCP name constant CS6.
It is used to define the Layer 3 packet's QoS parameter for RTP
GXV3240 Administration Guide Page 70 of 105