Advanced Settings/Tone Generator; Advanced Setting/Mpk General Settings (For Mpk App) - Grandstream Networks GXV3240 Administration Manual

ADVANCED SETTINGS/TONE GENERATOR

Call Progress Tones:
Dial Tone
Ring Back Tone
Busy Tone
Reorder Tone
Confirmation Tone
Call-Waiting Tone
PSTN Disconnect Tone
Call-Waiting Tone Gain
Default Ring Cadence

ADVANCED SETTING/MPK GENERAL SETTINGS (FOR MPK APP)

BLF Call-pick Prefix
Event List URI
Firmware Version 1.0.3.6
These settings are used to configure ring or tone frequencies based on
parameters from the local telecom provider. By default, they are set to
the North American standard.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val [,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern.
Up to three cadences are supported.
It is used to adjust the call waiting tone volume. Users can select "Low",
"Medium" or "High". The default setting is "Low".
It is used to define the ring cadence for the phone. The default setting is:
c=2000/4000.
It is used to configure the prefix prepended to the BLF extension if the
phone answer a call to the monitored party by the BLF key. The default
setting is ** for each account.
It is used to configure the event list BLF URI on the phone to monitor the
extensions in the list with MPK keys. This feature is based on Broadsoft
standard. It requires to fill in the BLF ID to the box. For example, if the
server provides the URI: BLF123@myserver.com, this filed should be
filled with BLF123. Then the monitored extensions will be populated in
the MPK app or Extension Board (if supported).
GXV3240 Administration Guide Page 66 of 105