Account Page Definitions; Account/General Settings - Grandstream Networks GXV3240 Administration Manual

ACCOUNT PAGE DEFINITIONS

The GXV3240 has six lines that can be configured to accommodate 6 independent SIP accounts. Each
SIP account has an individual configuration page.

ACCOUNT/GENERAL SETTINGS

Account Active
Account Name
SIP Server
SIP User ID
SIP Authentication ID
SIP Authentication Password
Voice Mail UserID
Name
Tel URI
Firmware Version 1.0.3.6
This field indicates if the account is active. The default value for the
IPVideoTalk account (Account 6) is "Yes" and the default value for the
first five accounts is "No".
It is used to configure the name associated with each account to be
displayed on the LCD.
It is used to configure the URL or IP address, and port of the SIP server.
This should be provided by VoIP service providers (ITSP).
It is used to configure the user account information, provided by your
VoIP service provider (ITSP). It's usually in the form of digits similar to
phone number or actually a phone number.
It is used to configure the SIP service subscriber's Authenticate ID used
for authentication. It can be identical to or different from the SIP User ID.
It is used to configure the account password required for the phone to
authenticate with the ITSP (SIP) server before the account can be
registered. After saving, it will appear as hidden for security purpose.
It is used to set if the phone system allows users to access the voice
messages by pressing the MESSAGE key on the phone. This ID is
usually the VM portal access number. For example, in UCM6100 IPPBX,
*97 could be used.
It is used to configure the SIP server subscriber's name (optional) that
will be used for Caller ID display. The configured content will be included
in the From, Contact and P-Preferred-Identity headers of SIP INVITE
message.
If the phone has an assigned PSTN telephone number, this field should
be set to "User=Phone". Then a "User=Phone" parameter will be
attached to the Request-Line and "To" header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead
of "SIP:" in the SIP request. The default setting is "Disable".
GXV3240 Administration Guide Page 42 of 105