Table of Contents
Advertisement
Busy Tone
Reorder Tone
Confirmation Tone
Call-Waiting Tone
PSTN disconnect Tone
Default Ring Cadence
MAINTENANCE PAGE DEFINITIONS
Maintenance/Network Settings
Address Type
PPPoE
Static IP
Alternate DNS Server
Layer 3 Qos
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS
802.1p Priority Value
802.1x Mode
Proxy
Maintenance/Wifi Settings
WiFi Functions
Wireless Mode
Network Type
Channel
ESSID
Grandstream Networks, Inc.
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period
of silence. In order to set a continuous ring, OFF should be zero.
Otherwise it will ring ON ms and a pause of OFF ms and then repeat
the pattern. Up to three cadences are supported.
This defines the ring cadence for the phone. The default setting is:
c=2000/4000;
This selects the type of IP address assigned: DHCP, PPPoE or Static
IP.
When PPPoE is selected, the user needs to enter the following:
PPPoE Account ID, PPPoE Password, PPPoE Service Name.
When Static IP is selected, the user needs to enter IP address,
Subnet Mask, Default Gateway, DNS Server 1 and DNS Server 2.
This field sets the alternate DNS server for the user.
This field defines the layer 3 QoS parameter. It is the value used for
IP Precedence, Diff-Serv or MPLS. The Default value is 0.
This field contains the value used for layer 2 VLAN tagging. The
Default value is 0.
This assigns the priority value of the Layer2 QoS packets. The
Default value is 0.
This field sets 802.1x Mode. The default value is disabled. If EAD-
MD5 is selected, users will be required to enter Identity and MD5
Password.
This field sets HTTP Proxy, HTTPS Proxy, FTP Proxy or No Proxy.
Using HTTP Proxy, other protocols can be applied by checking the
box "Apply to Other Protocol".
This parameter enables/disables the WiFi function. The default
setting is set to "Disable".
This parameter defines the wireless mode used. The GXV3175
supports 802.11b/g/n
This parameter defines the network type of the wireless network: Ad-
hoc or AP/Managed. By default, it is set to "AP or Managed".
This parameter defines the channel (1-10) for the wireless network.
The default setting is set to "Auto".
This parameter sets the ESSID for the Wireless network. Press
GXV3175 USER MANUAL
FIRMWARE VERSION 1.0.0.32
Page 36 of 68
Updated : 11/2010
Advertisement
Table of Contents
