Advanced Settings/Call Features - Grandstream Networks GXV3240 Administration Manual

ADVANCED SETTINGS/CALL FEATURES

Always Ring Speaker
Auto Conference
Disable Call-Waiting
Display Soft Keyboard
Dialer Interface Priority Display
Dialer Interface Display Interval
(m)
Filter Characters
Disable Call-Waiting Tone
Firmware Version 1.0.3.6
It is used to set if the speaker to play the ringtone if the speaker channel
is not set as default channel. If set to "Yes", the phone will force to play
the ring speaker in speaker channel. The default setting is "No". End
user might need this feature when the headset is connected.
It is used to allow the phone system to invite the all the call parties into a
conference by pressing the conf key. If it is disabled, the end user has to
add each call party to conference manually. The default setting is "No".
It is used disable call waiting feature. If it is checked, the phone system
will reject the second incoming call during an active session without
user's knowledge. But this missed call record will be saved to remind
users. The default setting is "No".
It is used to enable the QWERTY soft keyboard in the phone app/dialer
page. If it is set to "Yes", the soft keyboard will pop up by tapping the
input box. The default setting is "No".
It is recommended to disable the dial plan of the dial page on the
Account Settings page, or the call may fail if dial characters not conform
to the dial plan.
It is used to force the phone system to enter the dialer page on the LCD
screen. If it is enabled, the phone LCD will display the dialer interface
automatically from LCD screen idle mode (screen saver mode or screen
sleep mode). It needs coordinate with Dialer Interface Display Interval
setting. The default setting is "No".
It is used to configure the timer for the Dialer Interface Priority Display.
The timer will be started from the LCD screen goes to idle mode (screen
saver mode or screen sleep mode). If the Dialer Interface Priority
Display feature is enabled, the phone LCD will display the dialer
interface automatically from LCD screen idle mode (screen saver mode
or screen sleep mode) after the timer expired.
If it is configured with 0, the phone LCD screen will display the dialer
interface when user wakes up the phone from the screensaver mode or
screen sleep mode whatever the last apps is running. It needs
coordinate with Dialer Interface Display. The default setting is 1.
It is used to set the characters for filter when dial out numbers. Users
could set up multiple characters. For example, if set to "[()-]", when dial
(0571)-8800-8888, the character "()-" will be automatically filtered and
dial 057188008888 directly.
It is used to set if the phone system will play the call waiting tone if there
is another incoming call. If it is set to "Yes", the phone will only display
GXV3240 Administration Guide Page 63 of 105