Grandstream Networks GXV3240 Administration Manual page 59

No Key Entry Timeout (s)
Ring Timeout (s)
Mulituply Server Mode Group
Transfer on 3-way Conference
Hang up
Use # as Dial Key
DND Call Feature On
DND Call Feature Off
Conference URI
Broadsoft Call Center
Firmware Version 1.0.3.6
Otherwise, it will be disabled. The default setting is "No".
It is used to define the expiration timer (in seconds) for no key entry.
The dialed digit will be send out if no other digits entered within the set
period. The default value is 4 seconds. The valid range is from 1 to 15.
This feature does not work if the dialer page is entered via the
Account Widget on the phone.
It is used to define the expiration timer (in seconds) for the rings with
no answer. The default setting is 60. The valid range is from 10 to 300.
It is used to set to categorize accounts in server mode groups The
accounts in the same group will be combined as one and the account
widget will display the Caller ID in the account with lowest ID. The
phone can answer any incoming calls to each account in groups. If
user makes an outbound call, the phone system will use the lowest ID
account by default. If the account fails or SIP INVITE message is
timeout, the phone system will failover to the next account in the
group with higher account ID. If all the accounts are not available in
the group, the phone system will traverse all the accounts in the group
and notify the end users the session is failed.
It is to set if the phone system will end the three way conference
hosted on it if it hangs up. If set to "Yes", the conference will be
transferred from hosted party, thus other parties can continue the
conference without interruption. The default setting is unchecked.
It is used to set the phone system will use the "#" key as the "Send"
key. If set to "Yes", if the end user tap the "#" key, the phone system
will send out the typed digits. If set to "No", the "#" key is included as
part of the dialing string and please make sure the dial plan is properly
configured to allow dialing # out.
It is used to configure the feature code to enable the DND (Do Not
Disturb) feature for this account. If it is configured, the phone will dial
the feature code automatically when the DND feature is enabled.
It is used to configure the feature code to disable the DND (Do Not
Disturb) feature for this account. If it is configured, the phone will dial
the feature code automatically when the DND feature is disabled.
It is used to configure the network based conference URI (the
Broadsoft Standard). If it is configured, end user needs to tap the
N-way key during the conference to transfer the host to the remote
media server.
It is used to set if the Broadsoft Call center feature will be enabled for
GXV3240 Administration Guide Page 57 of 105