Grandstream Networks GXV3240 Administration Manual page 73

Layer 3 QoS for Video
Layer 2 QoS 802.1Q/VLAN
Tag
Layer 2 QoS 802.1p Priority
Value
PC Port VLAN Tag
PC Port Priority Value
PC Port Mode
User-Agent
802.1x mode
Identity
802.1 X Secret / 802.1 Private
Key Password
Firmware Version 1.0.3.6
messages in decimal pattern. This value is used for IP Precedence,
Diff-Serv or MPLS. The default setting is 48 which is equivalent to the
DSCP name constant CS6.
It is used to define the Layer 3 packet's QoS parameters for H.264
messages in decimal pattern. This value is used for IP Precedence,
Diff-Serv or MPLS. The default setting is 48 which is equivalent to the
DSCP name constant CS6.
It is used to define the VLAN Identifier of the Layer 2 frames. The
default value 0 which means the frame does not belong to any VLAN.
It is used to define the Priority Code Point within a Layer 2 frame
header. The valid range from 0 to 7. The Default value is 0 which is
equivalent to the Routine class for the Class of Service.
It is used to define the VLAN Identifier of the Layer 2 frame for PC
port. This tags the VLAN tag value on the target address received
from the LAN port of the phone then sends the value to the device
connected to the PC port.
Note:
VLAN tag value on the device connected to the PC port should be the
same as the VLAN tag value assigned to the PC port here.
It is used to define the Priority Code Point within a Layer 2 frame
header for PC port.
It is used to enable and define the PC port mode. If it is set to
"Mirrored", the traffic in the LAN port will go through PC port as well
and packets can be captured by connecting a PC to the PC port. The
default setting is "Enabled".
It is used to configure the User Agent URI to download phonebook
and screensaver files.
It is used to enable and select the 802.1x mode for the phone system.
The supported 802.1x modes are :

EAP-MD5

EAP-TLS

EAP-PEAP
The default setting is "Disable".
It is used to fill in the identity information for the selected 802.1x
mode. (This setting will be displayed only if 802.1 X mode is enabled).
It is used to fill in the password for the selected 802.1x mode. (This
setting will be displayed only if the 802.1 X mode is enabled).
GXV3240 Administration Guide Page 71 of 105