Grandstream Networks GXV3240 Administration Manual page 58

Refer-To Use Target Contact
Auto Answer
Send Anonymous
Anonymous Call Rejection
Call Log
Special Feature
Feature Key Synchronization
Enable Call Features
Firmware Version 1.0.3.6
411, 611 and 911
NOTE: In some cases where the user wishes to dial strings such as
*123 to activate voice mail or other applications provided by their
service provider, the * should be predefined inside the dial plan
feature. An example dial plan will be: { *x+ } which allows the user to
dial * followed by any length of numbers.
It is used to set if the phone system will use the target's Contact
header tag to the Refer-To header in the SIP REFER message during
an attended transfer. The default setting is "No".
It is set if the phone system will allow to answer an incoming call. If it
is set to "Yes", the phone will automatically enable the speaker phone
to answer all the incoming calls after a short reminding beep. If set to
"Enable Intercom/Paging", it will automatically answer the incoming
calls whose SIP INVITE includes auto-answer tag in the info header.
The default setting is "No".
It is used to set if the phone system will make an anonymous outgoing
call. If it is set to "Yes", the "From" header in the SIP INVITE
messages will be set to anonymous, essentially blocking the Caller ID
to be displayed. The default setting is "No".
If it is set to "Yes", the phone will reject the calls whose SIP INVITE
message includes Anonymous information in the From header. The
default setting is "No".
It is used to categorize the call logs saved for this account. If it is set to
"Log All", all the call logs of this account will be saved. If set to Log
Incoming/Outgoing Calls (Missed Calls Not Record), the whole call
history will be saved other than missed call. If it set to Disable Call All,
none of the call history will be saved. The default setting is "Log All".
It is to configure phone's setting to meet different vendors server
requirements. Users can choose from Standard, Broadsoft, CBCOM,
RNK, China Mobile, ZTE IMS, Mobotix, ZTE NGN, or Huawei IMS
depending on the server type. The default setting is "Standard".
It is used for the Broadsoft standard call feature synchronization. If it is
enabled, the phone will send SIP SUBSCRIBE message to the server
and receive SIP NOTIFY message from the server to synchronize the
DND, Call Forwarding and Call Center features. The default setting is
"Disable".
It is used to switch the local start command feature. If it is set to "Yes",
the feature will be enabled to recognize the local star code command.
GXV3240 Administration Guide Page 56 of 105