HP 6000 330s Owner's Manual page 92

Models 330S and 660S
HP Series 6000
Ejecting a Rewritable Optical Disk
To eject a rewritable optical disk, press the disk eject
button on the front panel of the rewritable optical disk
drive, wait for the disk to eject part way, and pull the
disk straight out of the disk port (see Figure 3-3). The
rewritable optical busy light displays the following sequence
when a rewritable optical disk is ejected from the disk port:
1. ON
The rewritable optical busy light goes on when the eject
sequence starts, and stays on for
5
seconds until the
rewritable optical disk spins down and the tray is in the
eject position. (The rewritable optical busy light stays
on for only 1 second if the rewritable optical disk has
already spun down.)
2. OFF
The rewritable optical busy light goes off and the
rewritable optical disk ej ects.
To eject a rewritable optical disk after a power failure
or if the normal eject switch fails, push the tip of an
emergency eject tool, part number C1701-88800, into the
emergency disk eject access hole (see Figure 3-3). (If you
don't have an eject tool, use a paper clip.)
The rewritable optical disk cannot be inserted after being
removed with the emergency eject tool until power is
cycled on the mass storage system.
Some application software may prohibit the ejection of a
disk until the user exits the application program.
3-8 Rewritable Optical Disk Drive