HP 6000 330s Owner's Manual page 107

HP Series 6000 Models 330S and 660S
9. Place the anti-static bag containing the rewritable
optical disk drive on the conductive sheet. Open the
bag, remove. the rewritable optical disk drive, and place
the rewritable optical disk drive on the conductive
sheet.
10. Place the anti-static bag containing the rewritable
optical controller PCA on the conductive sheet. Open
the bag, remove the controller PCA, and place the
controller PCA on the conductive sheet.
11. Set the address switch on the controller PCA to the
desired address (refer to "Setting the Address Switch").
12. Disconnect the ac power cord from the mass storage
system rear panel.
Ensure that the
[UNE-)
switch on the mass storage
system front panel is in the 0 (out) position, and that
the power cord is disconnected from the mass storage
system rear panel. Electrical shock may result if the
power cord is connected and the
[UNE-)
switch is in the 1
(in) position while the top cover is off.
Setting the SCSI Address Switches
The address switches on the back of your mass storage
system are for hard disk drives only.
The address switch on the rewritable optical controller
PCA (see Figure 3-5) enables you to select a unique SCSI
address for your rewritable optical disk drive. The address
switch is set to address 0 at the factory. Switches 1 through
8 on the address switch should be in the OFF (down)
position when you pull the rewritable optical controller
PCA out of the anti-static bag.
Rewritable Optical Disk Drive 3·23