HP 6000 330s Owner's Manual page 106

Models 330S and 660S HP Series 6000
Preparing to Install the Rewritable Optical Disk Drive
Before installing a rewritable optical disk drive, make sure
you have access to all sides of the mass storage system, and
that the mass storage system is near an ac power outlet.
1. Shut down the host computer.
2. Turn off power to both the host computer and the mass
storage system.
3. Disconnect the SCSI cable from the mass storage
system rear panel.
4. Set the
(LINEN)
switch on the mass storage system front
panel to the 0 (out) position.
5. Connect the power cord from the mass storage system
rear panel to an ac power outlet.
6. Place the rear of the mass storage system chassis on
the conductive sheet as shown in Figure 3-4.
7. Wrap one end of the wrist ground strap around your
wrist and apply the copper end to a flat, unpainted area
of the mass storage system chassis. The mass storage
system chassis, the conductive sheet, and your hand are
now at the same electrical potential.
Keep the wrist strap on until you have performed all the
steps in the installation procedure.
8. Slide the foam pad beneath the loose end of the
conductive sheet, while making sure the mass storage
system chassis maintains contact with the conductive
sheet.
3·22 Rewritable Optical Disk Drive