HP 6000 330s Owner's Manual page 111

HP Series 6000 Models 330S and 660S
To set the address switch to a different setting after
the rewritable optical disk drive and rewritable optical
controller PCA have been installed into the mass storage
system, perform the following steps:
1.
Set the mass storage system
(LINEN)
switch to the 0 (out)
position.
2. Disconnect the power cord from the mass storage system
rear panel.
3. Remove the front panel and top cover (refer to
"Removing the Front Panel and Top Cover" in this
chapter).
4. Verify that switches 1 through 5 are set to the OFF
(down) position.
5. Set switches 6 through 8 to the ON (up) or OFF (down)
position for the desired address (see Figure 3-5 and refer
to Table 3-3).
6. Install the front panel and top cover (refer to "Installing
the Front Panel and Top Cover" in this chapter).
7. Connect the power cord to the mass storage system rear
panel.
8. Set the mass storage system
(LINEN)
switch to the 1 (in)
position.
Rewritable Optical Disk Drive 3·27