Table of Contents
Advertisement
HP Series 6000
Models 330S and 660S
Preparing to Install a CD-ROM Drive
Before installing a CD-ROM drive, make sure you have
access to all sides of the mass storage system, and that the
mass storage system is near an ac power outlet.
1. Shut down the host computer.
2. Turn off power to both the host computer and the mass
storage system.
3. Disconnect the SCSI cables from the mass storage
system rear panel.
4. Set the
[LINEN)
switch on the mass storage system front
panel to the out position.
5. Set the
[LINEN)
switch to the 0 (out) position and
connect the power cord from the mass storage system
rear panel to an ac power outlet.
6. Wrap one end of the wrist ground strap around your
wrist and apply the copper end to a flat, unpainted area
of the mass storage system chassis. The mass storage
system chassis, the conductive sheet, and your hand are
now at the same electrical potential.
7. Place the rear of the mass storage system chassis on
the conductive sheet as shown in Figure 4-4.
Keep the wrist strap on until you have performed all the
steps in the installation procedure.
CD-ROM Drive 4-21
Advertisement
Table of Contents
