HP 6000 330s Owner's Manual page 125

HP Series 6000
Models 330S and 660S
Installing the Rewritable Optical Disk Drive into Slot 1
Install the rewritable optical disk drive into the mass
storage system chassis as follows (see Figure 3-14):
1. Lift the rewritable optical disk drive from the conductive
sheet, gently push the cables connected to the rewritable
optical controller PCA toward the center of the mass
storage system chassis, and lower the mounting tabs into
the mounting slots in the chassis rails.
Keep the cables which are connected to the rewritable
optical controller PCA positioned in the center of the mass
storage system chassis. The cables may be damaged if they
are caught between the rewritable optical disk drive and
the chassis rails.
2. Push down on the rewritable optical disk drive and
slide it on the chassis rails toward the front of the mass
storage system chassis until the mounting tabs lock into
the mounting slots and the rewritable optical disk drive
stops against the front of the chassis.
3. Tighten the T25 screw through the hole in the mass
storage system chassis and into the rewritable optical
disk drive securing tab.
Rewritable Optical Disk Drive 3-41