HP 6000 330s Owner's Manual page 148

Models 330S and 660S
4-12 CD-ROM Drive
HP Series 6000
To play an audio compact disc (CD) in your CD-ROM drive,
perform the following steps:
1. Place the CD-ROM Drive in continuous audio mode by
setting the PRTY, ARBT, and TEST switches (refer to
"Setting Switches to Continuous Audio Mode").
You must cycle power off and back on again for the
CD-ROM drive to recognize the new switch settings.
2. Connect a pair of miniature stereo headphones to the
headphone jack (see Figure 4-3).
3. Place an audio CD in the CD-ROM disk caddy.
4. Insert the disk caddy into the disk port (refer to
"Inserting CD-ROM Disks" in this chapter).
5. Move the volume switch (see Figure 4-3) from left to
right to increase the volume level of the audio signal in
three incremental steps.
6. Press the disk eject button momentarily
to
switch tracks
(songs).
7. Press and hold the disk eject button for more than one
second to eject the compact disc.