HP 6000 330s Owner's Manual page 142

Models 330S and 660S HP Series 6000
Inserting a Disk
To insert a CD-ROM disk caddy into the disk port, grasp
the edge of the disk caddy opposite the arrow and slide the
disk caddy into the disk port until you hear an audible click
(see Figure 4-2). The CD-ROM drive will automatically
load the CD-ROM disk caddy into the disk port.
If power to the CD-ROM drive has been switched off, the
disk load function will not be activated, and the CD-ROM
disk caddy will not be loaded into the disk port until
power is on.
If a CD-ROM disk caddy has been ejected but has not
been removed from the disk port, the CD-ROM disk
caddy must be pulled out more than 5mm from the disk
port and reinserted again before the disk load function
will be activated.
Ejecting a Disk
To eject a CD-ROM disk caddy, press the disk eject button
(see Figure 4-3) continuously for at least three seconds,
then pull the disk caddy straight out of the disk port.
4-6 CD-ROM Drive
If the eject button is pressed for less than three seconds,
the eject function will not be activated.
Some application software may prohibit the ejection of a
disk until the user exits the application program.