HP 6000 330s Owner's Manual page 31

HP Series 6000 Models 330S and 660S
The various power cords available are shown in the
Disk Product Specifications and Site Environmental
Requirements Handbook, part number 5955-3456.
The ac branch service must be properly current
protected by either a fuse or a circuit breaker.
Use only
3
UL/CSA approved power cord, SVT type,
rated for suitable voltage and current. These power
cords have two conductors plus a ground. Failure to
use the proper power cord could result in a shock or
fire hazard.
The power supply in your mass storage system has an
automatic ranging power supply, which makes a voltage
selector switch and external fuse unnecessary. Automatic
ranging power supplies have internal fuses that only fail if
the power supply itself malfunctions. For more information
regarding power requirements, refer to the specifications at
the end of this chapter.
Do not open the power supply. The power supply
contains no customer serviceable parts.
To attach the power cord:
1. Set the
(LlNE- )
switch
CD
to the 0 (out) position.
2. Plug the female end of the power cord into the -AC
LINE connector
CD
at the rear of the mass storage
system.
Mass Storage System 1-11