HP 6000 330s Owner's Manual page 33

HP Series 6000
Models 330S and 660S
Ensure that power is removed from all units of your host
computer before connecting (or disconnecting) the mass
storage system.
A Hewlett-Packard 92222 Series SCSI Peripheral
Interface Cable must be used to connect the mass storage
system to the SCSI bus. Failure to use these shielded
cables may cause the mass storage system to not meet its
Radio Frequency Interference (RFI) specifications.
When you are ready to return power to your system,
apply power to the mass storage system before applying
power to the host computer.
For host computer system configuration information, please
refer to the Peripheral Installation Guide, part number
97005-90000. Additional configuration information can be
found in the Application Execution Environment User's
Manual, part number 98515-90002, and in Volume 1 of
the HP-UX System Administrator Manual, part number
98594-90060.
The mass storage system is connected to the computer via
a SCSI interface cable plugged into the SCSI connector
CD
on the rear panel of the mass storage system. This cable
and a SCSI terminator are supplied with the computer's
SCSI interface hardware. (Additional SCSI interface cables,
extender, and terminator are available as mass storage
system accessories.) It is also necessary to set the address
switches
0
for the desired SCSI device address. Details of
SCSI bus connection and address selection are provided in
the following paragraphs.
Mass Storage System 1-13