Crank Replacement - Vision Fitness S70-02 Service Manual

5.9 Crank Replacement

1) Remove the shrouds as outlined in Section 5.1.
2) Detach the pedal arm from the crank bearing assembly (Figure A).
3) Remove the screw from the crank (Figure B).
FIGURE A
4) Insert an M10 screw (should be at least 40mm long) into the crank hole. Then turn the screw until the crank can be separated from the axle (Figure C).
5) Install the replacement crank. There is a flat spot on the drive axle shaft and the crank that should correspond (Figure D).
FIGURE C
6) Install the crank screw.
7) Reverse Steps 1-2 to re-assemble the unit. NOTE: The screw removed in Step 2 should be torqued to 80 N-m.
8) Test the Elliptical for function as outlined in Section 5.22.
CHAPTER 5: PART REPLACEMENT GUIDE
FIGURE B
FIGURE D
33