Drive Axle Set Replacement - Vision Fitness S70-02 Service Manual

5.8 Drive Axle Set Replacement

NOTE: A Vision Fitness special tool is needed to correctly replace a drive axle. Order part # 0000094817 from Vision Fitness CTS.
1) Remove the shrouds as outlined in Section 5.1.
2) Remove both belts as outlined in Sections 5.5 & 5.6.
3) On the left side of the frame, remove the retainer clip that holds the drive axle bearings in the frame (Figure A).
4) Install an M10 screw into the drive axle (Figure B).
FIGURE A
5) Turn the screw until the head is close to the drive axle (Figure C).
6) Use a mallet to hit the screw until the drive axle assembly is loose in the frame and remove it (Figure D).
FIGURE C
7) Assemble the Vision Fitness tool as shown, and install the tool into the hole in the frame (Figure E).
8) Use a rubber mallet to hit the end of the tool until the bearing can be removed from the frame (Figure F).
FIGURE E
CHAPTER 5: PART REPLACEMENT GUIDE
FIGURE B
FIGURE D
FIGURE F
29