Vision Fitness S70-02 Service Manual page 31

5.8 Drive Axle Set Replacement – Continued
15) Turn the nut until the iron plate is close to the frame on the right side (Figure M).
16) Remove the tools. Then insert the loose bearing sent with the drive axle set into the hole in the frame on the left side (Figure N).
FIGURE M
17) Again use the screw, washer and nut to attach tool #1 to the drive axle (Figure O).
18) Turn the screw at least 4 full revolutions into the drive axle. Then turn the nut until it is close to the cup portion of the tool (Figure P).
FIGURE O
19) Use a wrench to hold the screw. Then turn the nut to push the bearing into the hole in the frame (Figure Q).
20) Insert the retainer clip to hold the bearing in the frame (Figure R).
FIGURE Q
CHAPTER 5: PART REPLACEMENT GUIDE
FIGURE N
FIGURE P
FIGURE R
31