Vision Fitness S70-02 Service Manual page 50

CHAPTER 6: SOFTWARE UPGRADE PROCEDURE
6.1 Software Upgrade Instructions – Continued
B. VISION S70 ELLIPTICAL SOFTWARE UPGRADE PROCEDURE
1. Connect the MSP-GANG430 hardware, PC, and console as shown in Figure A.
2. Click on the GANG430 icon located in the program group specified during installation of the software (the default group is ADT430). The MSP430
FLASH Gang Programmer GUI is displayed on the screen as shown in Figure B.
The status message in the GUI displays the message "MSP-GANG430 Gang Programmer connected." If this message is not displayed, check the COM
Port selection in the communication settings of PC and the MSP-GANG430 connections.
3. Follow sequence 3.1 - 3.8 to setup the parameter as shown in Figure C.
3.1 Select the H/W Self Test function on the maintenance menu.
3.2 Selects the PC serial port used to communicate with the MSP-GANG430.
FIGURE A
FIGURE B
50