Vision Fitness S70-02 Service Manual page 30

5.8 Drive Axle Set Replacement – Continued
9) The drive axle should have come with an iron plate installed (Figure G).
10) Assemble the Vision fitness tool as shown in Figure H.
FIGURE G
11) Slide the drive axle into the hole in the frame. Install tool #2 from Figure H into the opposite side hole in the frame (Figure I).
12) Mount the #1 tool behind the #2 tool. Use the screw, washer and nut to attach tool #1 tool to the drive axle Figure J).
FIGURE I
13) Turn the screw at least 4 full revolutions into the drive axle. Then turn the nut until it is close to the cup portion of the tool (Figure K).
14) Use a wrench to hold the screw. Then turn the nut to pull the drive axle into the frame (Figure L).
FIGURE K
CHAPTER 5: PART REPLACEMENT GUIDE
Part Number: 0000094817
#1
FIGURE H
FIGURE J
FIGURE L
#2
30