Parts Listing - Ricoh C217 Service Manual

18. Snap out the communication port cover plate from the lower center of
therear cover.
19. Using the cable tie [G], fasten the Interface Harness to the Interface
Bracket [D] (at the indentation of the bracket). Refer to figures 1 and 2.
20. Re-assemble the machine.
21. The last installation step is to attach the Ferritecore (not illustrated) onto
the interconnect cable that is used to connect the Controller Box to the
Priport machine. "Snap" the Ferritecore around the cable nearest the
MALE end of the cable (connects to the Priport)
22. Refer to the PCRIP - 10 Priport Controller "Installation Guide" for the
proper cabling configuration.
23. Refer to the PCRIP - 10 Priport Controller "User's Guide" for the proper
set-up and operation procedures.

7.4 PARTS LISTING:

INTERFACE UNIT-10 TYPE 2 KIT
QUANTITY
1 EPROM for Main Control PCB (IC108)
1 Interface Harness with Mounting Bracket
1 Video Interface PCB
3 Phillips Screw M4x8 with flat washer
3 Phillips Screw M3x8 with flat washer
1 Interface Bracket
1 Long Stud
1 Board Spacer
1 Cable tie
1 Ferritecore
1 Diagnostic Plug
* Optional Test Tool, Refer to Section 7.6, Step 8.
*
SM
DESCRIPTION
7-7 C217