Input Check Mode - Ricoh C217 Service Manual

4.3 INPUT CHECK MODE

By entering a number listed below, the input level of each electrical device
can be checked. Depending on the device's condition, the beeper will sound
and the machine status indicators will light.
No. Device
1 Feed Start Timing Sensor
2 Feed Jam Timing Sensor
3 Exit Jam Timing Sensor
Master Eject Position
4
Sensor
5 Drum Master Sensor
6 Cover Safety
7 Master End Sensor
8 Master Cut Switch
9 Right Cutter Switch
10 Left Cutter Switch
11 Paper End Sensor
12 Registration Sensor
13 Exit Sensor
Master Clamper Switch
14
(Open)
Master Clamper Switch
15
(Close)
16 Original Set Sensor
Original Registration
17
Sensor
18 ADF Open Switch
19 Master Eject Sensor
20 Pressure Plate H.P. Sensor The sensor is actuated
21 Full Master Sensor
22 Paper Table Set Switch
23 DIP SW 103-1
24 DIP SW 103-2
25 DIP SW 103-3
26 DIP SW 103-4
27 DIP SW 103-5
28 DIP SW 103-6
29 DIP SW 103-7
30 DIP SW 103-8
SM
Conditions when the beeper will sound
The sensor is actuated
The sensor is actuated
The sensor is actuated
The sensor is actuated
The sensor detects a master on the drum
The scanner unit is open
The sensor detects no master
The switch is pressed
The switch is actuated
The switch is actuated
The sensor detects no paper
The sensor detects paper
The sensor detects paper
The clamper is open
The clamper is closed
The sensor detects an original
The sensor detects an original
The ADF is closed
The sensor is actuated
The sensor is actuated
The switch is on
The switch is on
The switch is on
The switch is on
The switch is on
The switch is on
The switch is on
The switch is on
The switch is on
4-9 C225