Output Check Mode - Ricoh C217 Service Manual

4.4 OUTPUT CHECK MODE

You can individually turn on each of the electrical device listed below . The
procedure is as follows:
1. Select the output check mode. Refer to page 4-8.
2. Enter the number of the device to be tested.
3. Press the Print key to turn on the device.
4. To turn off the device, press the Clear key.
NOTE: Several of the are devices are only turned on for the duration
that the Print key is pressed (marked with *).
+
CAUTION:
1. Do not manually turn the drum or use the output modes (NO. 10 or
11) when the clamper is opened with the output mode.
2. Do not open the clamper when the drum is not at either the master
feed or eject drum stop positions. Use the drum stop functions
(No. 15 or 16) before opening the clamper.
No. Device/Function
Thermal Head
1
2 Paper Feed Clutch *
3 Pressure Release Solenoid *
4 Master Eject Motor *
5 Ink Supply Motor *
Master Cutter Motor
6
Print Counter
7
Master Counter
8
9 Exposure Lamp
Master Clamper Motor (Open) *
10
Master Clamper Motor (Close) *
11
12 Master Feed Motor
13 Original Feed Motor
14 Shading Distortion Correction
Drum Stop (Master Exit)
15
Drum Stop (Master Feed)
16
Pressure Plate Motor *
17 (To Home Position)
C225
Power is applied to the thermal head for 30
seconds after the Print key is pressed. While the
power is applied to the thermal head, the beeper
sounds.
The motor will stop when either of the cutter
switches is activated.
The counter is increased by one each time the
Print key is pressed.
The counter is increased by one each time the
Print key is pressed.
The motor will stop when the master clamper
switch detects the clamper open condition.
The motor will stop when the master clamper
switch detects the clamper closed condition.
The shading distortion memory is rewritten.
The drum will rotate and stop at the master eject
position.
The drum will rotate and stop at the master feed
position.
The motor will move the pressure plate towards to
the home position. The motor will stop when the
pressure plate H.P. sensor is actuated.
4-10
Note
SM