Exit Roller And Exit Pawl Removal - Ricoh C217 Service Manual

8.3 EXIT ROLLER AND EXIT PAWL REMOVAL

[A]
[B]
[D]
[C]
1. Turn off the main switch and disconnect the power plug.
2. Remove the air knife camber (2 screws).
3. Open the paper delivery fence.
4. While pushing the joint [A] to the rear, remove the shaft [B] with the lower
exit rollers.
NOTE: When installing, be sure to meet the grooves [C] of the lower
rollers with the plates [D] beside the upper rollers.
5. Slide the exit pawl assemblies [E] to the middle of the shaft, which is the
the thinnest area, for removal.
CAUTION: Do not disassemble the exit pawl assembly. If it is
disassembled, the clearance between the exit pawl and
the drum must be checked after reinstallation.
C217
[E]
5-42 SM