Fiat 1998 Marea Service Manual page 810

Marea-Marea Weekend
1999 range
Copyright Fiat Auto
Electrical equipment
Air Bag - New features
- fit and tighten the rear retaining bolts begin-
ning from the inner edge ( 1 ) and continuing
from the outer edge (2) to the torque of 2.4
daNm.
The seat must be fastened to the floor
without distorting
necessary, adjust
shown magnified in the figure and en-
sure they are free.
NOTE Do not lift the seat to fit the retaining
bolts at this stage.
move the seat to FULLY BACK position at
the end of its travel using the guide control
lever;
Ensure the guide control lever is cor-
rectly fitted (clicks into place).
fit and tighten the front retaining bolts be-
ginning from the inner edge (1) and con-
tinuing from the outer edge (2) to the
torque of 2.4 daNm.
The seat must be fastened to the floor
without distorting
necessary, adjust
shown magnified in the figure and en-
sure they are free.
NOTE Whenever work is carried out on the air
bag system, it is COMPULSORY
check the system is working
using the relevant testers.
55.
the guide rails. It
the floating nuts
the guide rails. If
the floating nuts
to
properly
1 5