Fiat 1998 Marea Service Manual page 320

Engine
Fuel system
10.
Removing test equipment
Remove the test equipment 1860955000 with the ignition key in the OFF position, proceeding as de-
scribed below:
- introduce the end of the pipe connected to the valve (c) into a suitable container;
- open the valve (c) and drain the excess fuel into the container;
- keep the pipe in the container and disconnect the end of the supply pipe from the female connector for
adapator (A) keeping the connector upwards;
- let the fuel in the pipes flow into the container;
- disconnect the terminal of adapator (B) from the connector on the fuel manifold and let the residual fuel
flow from the pipes into the container;
- reconnect the fuel supply pipe to the fuel manifold.
50
<•>
1866149001
< • >
Marea- Marea Weekend ©
Check the fuel consumption using the
FLOWTRONIC equipment 1866149001
To carry out the test, the equipment should
be configured with the connectors shown in
the diagrams:
A. supply pipe side
B. fuel manifold side
If this is not the case, make the adjustment,
proceeding as described below:
- cut the terminal on the inlet pipe for the
FLOWTRONIC equipment and replace it
with a female rapid connector (1) contained
in Kit No. 1860955003, as illustrated in fig-
ure A;
cut the terminal on the outlet pipe for the
FLOWTRONIC equipment and replace it
with a male connecto (2) contained in Kit
No. 1860955003, as illustrated in figure B.
The connectors removed should be
recovered and kept for any future
connections
16v
99 update
Print n° 506.763/15