Fiat 1998 Marea Service Manual page 413

Marea-Marea Weekend®™
'99 range
Copyright by Fiat Auto
®m>
1. Disconnect the electrical connector for the
potentiometer cutting off the wiring as
close as possible to the plastic duct which
retains it, taking care not to damage the
surrounding cables.
REFITTING
- Carry out the operations described above in
the reverse order.
- Position the new potentiometer and restore
the routing of the new bridge fastening it
under the tunnel so that the latter does not
impede the movement of the climate con-
trol
noise/vibrations whilst the vehicle is being
driven.
2. Connect the diagnostic equipment to the
socket in the engine compartment, on the
right side of the vehicle, in the area of the
pillar.
With the pedal in the end of travel posi-
tion, check that the voltage reading on
the instrument is 3.8V ± IV.
3. To correct the voltage readings with the
accelerator
regulate the adjustment device and repeat
the measuring procedure using the diag-
nostic equipment.
4F47MJ02
Engine
Operations on vehicle
unit and does not
in the maximum position,
10.
produce
21