Removing Test Equipment - Fiat 1998 Marea Service Manual

Engine
Fuel system
10.

Removing test equipment

Remove the test equipment 1860955000 with the ignition key in the OFF position proceeding as follows:
- introduce the end of the pipe connected to the valve (c) in a suitable container;
- open the valve (c) and drain the excess fuel into the container;
- keep the pipe in the container and disconnect the end of the supply pipe from the female connector for
adaptor (A) holding the connector upwards;
- let the fuel in the pipes flow into the container;
- disconnect the end of the adapator (B) from the rapid connector and let the fuel flow from the pipes
into the container;
- reconnect the fuel supply pipe.
46
Marea- Marea Weekend &
Check the fuel consumption using the
< • >
FLOWTRONIC equipment 1866149001
To carry out the test the equipment must be
configured with the connectors as illustrated in
the diagrams:
A. supply pipe side
B. fuel manifold side
If this is not the case, carry out the adjustment,
following the instructions given below:
- cut the end of the inlet pipe for the FLOW-
TRONIC equipment and replace it with a
femal rapid connector (1), contained in Kit
No. 186095503, as illustrated in figure A;
- cut the end of the outlet pipe for the
FLOWTRONIC equipment and replace it
with a male connector (2), contained in Kit
No. 1860955003, as illustrated in figure B.
The connectors which have been re-
moved should be recovered and kept
for future connections.
99 range
Print n° 506.763/14