SMB/CIFS Network Setup Procedures
To use an SMB/CIFS network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p . 8-3 .)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser).
2
Computer Settings for Printing/Sending a Fax (See e-Manual > Network)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a computer. For the equipment
needed, see "Optional Equipment and System Requirements for Connecting to a Network, " on p. 4-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p . 8-7 .)
Specify the settings of the computer receiving data sent from the machine.
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
8
The only base protocols supported by the machine for SMB/CIFS networks are TCP/IPv4 and TCP/IPv6. NetBEUI is not supported (SMB is
used as a print application).
•
If you are using the imagePASS or the PS-GX, see the manual provided with the imagePASS or the PS-GX.
•
If you are using the imagePASS or the PS-GX, some functions are not available with this machine. For details, see the manual provided with
the imagePASS or the PS-GX.
8-2