Settings Common To Tcp/Ipv4 And Tcp/Ipv6 - Canon imageRunner C5051 Getting Started

Settings Common to TCP/IPv4 and TCP/IPv6

This section describes the procedure for specifying the settings common to TCP/IPv4 and TCP/IPv6 using the control panel.
Specify the settings required for your network environment. If you want to use both TCP/IPv4 communications and TCP/IPv6
communications, specify the settings required for both protocols.
After performing this procedure, follow the procedure in "Confirming TCP/IPv4 Settings, " on p. 6-24 and "Confirming TCP/IPv6
Settings, " on p. 6-25 to check whether the network settings are correct.
1
On the TCP/IP Settings screen, press [LPD Print Settings] → specify the following .
6
[On]: You can use LPD as the print application.
•
You can only output a banner page if you are using the imageRUNNER ADVANCE C5051i/C5045i/C5035i/C5030i, or the PCL Printer
Kit or the PS Printer Kit with the imageRUNNER ADVANCE C5051/C5045/C5035/C5030.
•
Output of a banner page is set on a print-job basis. Even if [On] is selected for <LPD Banner Page>, a banner page cannot be
output for a print job unless it is set.
6-16
Protocol Settings