Gateway Numbers; Email Address; Myalarm Options - Bosch solution 6000 Installation Manual

Comms > MyAlarm >

MyAlarm Options

1
Reserved
2 Reserved
3 Reserved
4 Reserved
5
Reserved
6 Reserved
7 Reserved
8 Reserved
This location is a Bit option field.
Comms > MyAlarm >

Gateway Numbers

SMS Primary
1 Digits
1 8 3 2 1 3
SMS Secondary
1 Digits
1 8 3 2 1 3
Email
1 Digits
1 8 3 2 1 3
MyAlarm
1 Digits
1 8 3 2 1 3
This menu allows the installer to program the gateway
telephone numbers for both SMS and email reporting.
The MyAlarm gateway telephone number is currently not
used.
When SMS reporting, the control panel will call the SMS
primary number first. If the control panel fails to report
via the SMS primary number, the control panel will then
use the SMS secondary number until all current event
reports are sent. The next time the control panel needs
to report, the control panel will revert back to the SMS
primary number.
1) Enter [MENU] + [5] + [5] + [7].
SMS Primary
SMS Secondary
Email

Press OK or MENU
2) Highlight the gateway telephone number to
change and press [OK]. The keypad will display the
current gateway telephone number.
Bosch Security Systems 07/14 BLCC610I
MENU 5-5-2

 MENU 5-5-7
4 5 0 6 4 1
4 5 1 8 2 5
4 5 2 5 0 5
4 5 2 5 0 5
Solution 6000
Gateway Numbers SMS Pri
183213450641
N Press  0-9 OK to SAVE
N
3) Using the numeric keys, enter all the digits of the
N gateway telephone number. You can change a
single digit by scrolling the cursor left or right. For
N
special characters including, pause, * or #, use the
N
up and down arrow keys.
N
4) Press [OK] to save and exit or press [MENU] to exit
N
without saving.
N
Comms > MyAlarm >

Email Address

1
Email
Address
This menu allows the master user to program an email
address that the system will send email reports to. A
32
maximum of 80 characters can be used to program the
email address.
1) Enter your Master PIN + [MENU].
32
2) Enter [5] + [5] + [8] + [OK].
The keypad will display the current email address.
32
Email Address
32
Press 
3) Use the numeric, [0] to [9], [] and [] keys to enter
or change the email address as required.
At any time you can use the [] and [] keys to scroll
through the complete list of available characters.
To clear all characters from the cursor position to the
right, press the [OFF] key.
4) When the email address is complete, press [OK] to
save and exit, or press [MENU] to exit without saving.
To stop email reporting simply remove the email
address or disable all of the email options in MENU
5-5-9.
When entering an email address the @ symbol is
i
represented on the keypad display as
Note
To enter this character press the 1 key repeatedly until
the symbol appears in the display.
Installation Manual Comms Programming
 
-
 
Characters

OK to SAVE
MENU 5-5-8
80
.
9-17